Did you know that the typical party host spends up to 1-hour inflating, sealing, and stringing helium-filled balloons?! Creative Balloons Manufacturing produced a re-usable & recyclable helium balloon valve that takes the stress and hassle out of balloon decorating! The E-Z Safety Seal Balloon Valves allows you to inflate, seal, and string a helium-filled latex balloon in only 6 seconds! Plus, the valved balloons are re-inflatable, too! These balloon valves are also ideal for “last-minute party decorating”, as it’s intended to help party hosts save time and energy decorating with helium-filled balloons, just minutes before their party starts. Since helium is lighter than air, latex balloons naturally start to deflate after several hours. That’s why they encourage customers to inflate the valved balloons a few minutes before guests arrive, as most parties last 3-4 hours. Easy peasy! Step one- insert the E-Z Safety Seal Balloon Valve into the opening of a balloon, as shown above. Step two- fill your balloon in 4-6 seconds using a portable helium tank. Step three- No need to tie off the balloon! Simply pull down the pre-attached string and you’re done! AND, that’s not it…the valves are reusable! After the party, remove the valves from the balloons and then use them again for a future event. A party host can now inflate 50 valved balloons in about 5-10 minutes! If they were to fill balloons the “old-fashioned” way, it would take 45-60 minutes! Wow, what a difference!
This post is sponsored by E-Z Safety Seal Balloon Valves. Compensation and or products may have been received. However, all opinions are my own.
